im just trying to find out if anyone else has been having problems with using a pure energy on an invert mini. im trying to figure out if its just a little tweak i need to work out because often when working the trigger i will lose pressure in the marker momentarily and about 3 balls will roll out of the barrel until i let off and let it re-pressurize. ive heard that the threading on the pure energy tank dont really get along with the threading in the mini. just wondering what everyone thought

try adjusting the pressure at the reg... make sure you're getting a good solid steady pressure, then make sure all the poppet valves are clean and clear of any gunk or debris... you STILL have not brought that thing for me to look at... douchebag.

I had a problem with my MINI when it was cold outside (33-35 degrees) and had the Pressure set to LOW (180psi) and some dow33 had gotten in around the Poppet and I had to clean that out... I upped the pressure back to 198psi and worked just fine... BTW I was using a PE 68/3000 carbon wrapped high flow rate tank... So check to make sure you don't have the pressure set to low....

Hope this helps out...

Green Beret Sport Parachute Activity Member (Fort Bragg N.C.)
Scout/Recon 6th FJR-OK D-Day 2007
Sergeant Major 6th FJR-OK D-Day 2008/2009
Automaggot #134

I'm not sure if the mini has an adjustable pin depressor but it could be that you need to let the pin depressor out a little. If it isn't sticking out far enough then the tank won't open as much and less air will be allowed into the marker causing shot drop off and low velocity.

haha i know nix. everytime i come to your house its more to the tune of drinking and watching a fight, or recently playing COD4. lol someday ill stop being a lazy ass and bring it by when we are both sober