Black Dragun Issues. PLEASE HELP!!!

[Colin27]

my black dragun is pretty much an electric spyder because i switched some parts off my spyder and everything fit fine so ill base it on that. the gun will shoot one shot and then act like a gun out of air so i thought it might just not be catching but i replaced the screw so i dont think its that. it does have an electric trigger frame so it is electric. if anyone has any suggestions/advice im extreamly open. thanks
Colin

[warpedx]

I remember my black dragun, got it right when they came out. It had issues with the sear not catching all the way, I'd often have to pull the bolt back another quarter inch to get the marker to fire again.
Your issue could be one of two things. Either the oring on the hammer is toast, or the sear is not catching at all.
I'd start by replacing the oring. If the problem persists, make sure you are runnning the right pressures, and that the sear is clean.

[Colin27]

where exactly is the sear? i have replaced the oring and i also have to pull it back about that much.

[warpedx]

The sear is the part in the trigger frame that catches on the hammer. It should be clean and smooth so the hammer can glide over it until it catches on the groove.