T.e.s Faq's, Read Befor U Post!

[20bps_tes]

Turning off the Eye: hold down the trigger for around 8 seconds.

Turning the Eye back on: turn your TES off then back on again.

adjusting the reg?: using the allen key provided, un-screw the large allen nut counter-clockwise to increase pressure and velocity. Turn it clockwise to decrease velocity and pressure. you may need to fire the gun to see the change on the guage, so don't just crank it and wait to see it on your guage. Do it slowly and fire your marker when adjusting the pressure.

is the stock barrel any good?: as far as stock barrels go, it's pretty good...until you break a ball. After that you will need a good clean to get back up to decent accuracy. A new barrel is not a must, but it will help performance. Also, the stock barrel is 12" long.

does the TES work on co2 ?: yes, but not at its best. You may break O-Rings, and potentially suffer freeze ups and velocity spikes.(a anti syphon kit is highly recommended)

How do I take the bolt out of my TES?: It is easy, just un**** your marker, grab the top ****ing pin, and pull up (hard if u have to). There's no need to unscrew it, because it uses a little ball-bearing to keep it in,and u will ave to loc-tight the screw back in. To replace it, Place the bolt back into the marker, and push the pin back down. It should go in about halfway, then move it back and forth so that the bolt pin is aligned with the metal receiver in the striker.

Leaking front block?: Get bigger o-rings(tank o-rings) and roll up teflon tape to put at the last o-ring(one closest to the LPC), then grease it up with some dow 33. You can also try and put some thread sealer on the screw that holds the front block in.(Thanks Reloaded for the dow33)

double shooting, not burping?: This is where your marker double shoots every now and then. To fix this try putting a lighter main spring in. and stretch the sear spring abit, (the stock tes sear spring is pritty light).

How do I take out the internals?: find the quick strip pin and push it out. the back plug , spring guide, main spring , bumper , bolt and striker.should come out the back. Make sure u let the back plug out slowley as there is a spring and it will shoot out the back if you dont hold on to the back plug

chopping?: get a faster loader (Halo B, QLoader, etc), make sure your paint-to-bore match is correct, adjust your ball detent, use quality paint, invest in a JAM bolt for added insurance against chops.(Thank you Reloaded)

Tip: When replacing your ball detent, be sure not to screw it in to tightly, this will strip the threads and it will break apart the ball detent, it will make it very loose in the future and may be lost.
Also, the TES can take auto****er ball detents with minor adjustments (they have to be the round ones the squar ones dont work) [Un-Verified].

Tip:the TES will take Intimidator/timmy bolts (u want one with a ball detent slit in it, and u also need to use the stock TES bolt pin in the Intimidator bolt)

UPGRADES: here a list of upgrades and where they can be found. (Good Job schoolsukz08)

These are a few threads I thought might help:Bodger's Switch Tutorial, Otters Customs, Pbreview FAQ,

*Note*I'm not responsible if your mess up your gun after reading this FAQ, please take caution when doing some of the things I have stated

=======================================
if there is any thing i would like added fell free to pm me ;D