![]() |
![]() |
![]() |
![]() |
|
||||
|
Thank you private pump, I'll try that and let you know. If that won't work, I'll call that number jester sent. Sometimes those pesky problems have a solution that right under your nose. Maybe I have looked to hard and went right past the obvious. thanks, everyone. I'll let you know if one of these work.
|
![]() |
![]() |
|
||||
|
Took my hopper apart, again, and spun it by hand. Noticed the drive cone (stock) was hitting the casing some. I cleaned the eyes, and sanded the casing to allow clearance of the cone. I ran a few hoppers through, seemed to work fine. But , that is what it was doing before. I have to try it on the field. I'll post results for those watching this thread.
|
![]() |
![]() |
|
||||
|
Well, it's still doing it. Funny though, when it is off the gun, it works fine. No matter how much paint I try to cram into it to get it to jam. I put it on the gun, and it starts the red/green deal again. Cleaned the eyes, everythings seems to be good. Getting frustrated with it at this point. A different hopper is looking better and better.
|
![]() |
![]() |
|
||||
|
then it's not the hopper, its the gun. this weekend my gun was shooting like crap all day and i thought it was the hopper but it was a dead battery in the gun, and after i replaced it it shot like new. try replacing the battery in the gun so it shoots properly.
Pump: It's where the boys are separated from the men.
Proud owner of the one and only Red, White, and Blue CCM Series 6. MMK |
![]() |
![]() |
|
||||
|
I'm liking the ideas, but I had replaced my battery that day before I played. I also cleaned the eyes on my gun too, which appeared fine when cleaned. When it goes red/green, I have to start using the rip drive. The rip drive is easy to turn when I use it. There is no jam, the stupid thing is just not turning. I believe I will just replace the whole battery wire part, from the board to the battery pack. I still have a sneaky suspicion that it's voltage related. --- If this doesn't do it, I am contacting Halo by phone. Thanks again for everyones input.
Wubby, I have had that happen to me too. Seems like thats the first place I start when stuff starts messing up. I have "fixed" (ha,ha) a lot of people's guns with a battery. |
![]() |
![]() |
|
||||
|
It's sounding like it may be your board. Definitely call Paintball Soultions. They hear all the problems from all over. I had a customer whose Mini spit the plug out of the bottom of the solenoid. Freaked me out, becasue I've never seen it. Especially at normal op pressure. Tech I spoke with knew exactly what it was and is sending a new solenoid. The gun was less than a week old and luckily, we had it's twin in stock. So he got a new gun and I'll have mine back in stick as soon as I get the new solenoid. They're a good source for tech problems.
|
![]() |
![]() |
|
||||
|
Mr. Jester, I believe your right. I'll call them in the morning. If I had the schematics for it, I might could troubleshoot the board. I don't think Halo(odessy) will let those go though. It's dropping voltage somewhere I think. Acts like it needs more power. From day 1 I about had to put new batts in every time out. I would do the "lick" test and get my tongue zapped good when the hopper was wanting new batts. Save a bowl of your chili for me. I'm in that upside down pool at B.Claw (as general). All that chili, and no air circulation. It could be a long day. Maybe, if I eat alot of chili, I'll be able to "fight" back. lol I've got to get a fan for that thing. Perhaps, a air freshener under my masked taped by my nose. German South, might have to relocate the base. lol, I still want some chili.
|
![]() |
![]() |
|
||||
|
Quote:
See ya at that upside-down pool boss dude, I put in South German at BC. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|
Search Engine Optimization by vBSEO 3.2.0
|
Powered by vBulletin Copyright ©2000 - 2008, Jelsoft Enterprises Ltd. |